MOTORS FOR HIGH DEMAND
(GM SERIES)

The motors of the GM series are characterized by particularly precise concentricity and show a flexible performance spectrum that predestines them for applications that require a wide range of requirements.
They are particularly reliable and, in the IP 54 version, popular in the pharmaceutical industry.

SPECIFICATIONS

TECHNICAL DATA
SPEED AND TORQUE

Solid line = continuous operation
At an ambient temperature of 25 ° C, the maximum anchor temperature is reached under permanent load.
Dashed line = repeatable work area (S-3)
This area can be used under different load characteristics. It is limited by the influence of temperature, commutation and demagnetization.
Dashed two-dot line = short-term operation
The motor may be loaded briefly and repeatedly. If this range is exceeded, the motor will be irreversibly damaged.
Remarks
Tolerances according to VDE 0530. For values ​​not specified according to VDE 0530, a tolerance of +/- 10% applies.
If the drive shaft is fitted with a shaft seal, a slightly lower torque is to be expected due to friction losses. The technical data given in the table and the performance curves relate to a DC voltage supply with a permissible harmonic content of up to 5%. The data are only valid for use in an ambient temperature of 0 ° C to 40 ° C. This range must neither be exceeded nor fallen below, otherwise there is a risk of permanent magnetic weakening.
Subject to technical changes

EQUIPMENT

Accessories and add-on components for engines

Gearbox: Planetary gearboxes of the PLE series are available for all motors. An assignment and a detailed description of the gearbox to the individual motor types can be found here …
Brakes: The brakes are permanent magnet-excited holding brakes. The supply voltage for the brakes is 24 V. The respective holding torques are assigned to the motors.
Power is supplied via a separate connection line (special versions on request).
Encoder: Two different encoder types are optionally available:
Type 1: 2-channel encoder with a pulse number of 500 or 1000 pulses / rev
Type 2: 6-channel encoder with 500 or 1000 pulses / rev, each with a 5 V signal.
Tachos: DC tacho generators with a voltage constant of 10V are used as tachos. Detailed technical data on request.
Cover hood: A suitable cover hood is available to protect the 2nd shaft end.
DC servo controller: An assignment of the controller to the motor types and a description of the controller can be found in the section Servo controller.

SPECIAL DESIGN

Electrical connections with 1 m cable
Protection class IP 40
Insulation class F
Optionally with or without a 2nd shaft end
Color quartz gray
Ball bearings in 2Z design

SPECIAL VERSION

Electrical connection with plug connection
Special voltages
Motor shaft and connection flange according to customer drawing
Protection class IP 54